Samsung SR8875 Instrukcja Użytkownika Pobierz pdf (Strona 20)

20_ Operating the cleaner

Operating the cleaner

INSTALLATION ORDER

1. Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn on the Power Switch at the

bottom of the main unit.

2. Installing the Charger

To charge the robotic vacuum cleaner, you must ﬁ rst install

the charger. Since the battery is discharged when the

product is purchased, you must fully charge the battery

before use.

3. Charging the Battery

You should charge the battery completely before using the

robotic vacuum cleaner.

4. Installing the VIRTUAL GUARD

You can conﬁ ne the robotic vacuum cleaner to a particular

section by using Fence (virtual wall) mode or clean several

sections one by one using Guard (virtual door) mode.

INSTALLING THE ROBOTIC VACUUM CLEANER

TURNING THE POWER SWITCH ON OR OFF

If the Power Switch is turned off, the robotic vacuum cleaner will not be charged

even if it is docked with the charger station.

CAUTION

To use the robotic vacuum cleaner, you must turn the

Power Switch on.

If you turn the Power Switch off, all settings will be reset.

1. Turn over the main unit and turn the Power Switch

on.

- If the icons are not turned on, it indicates that the

battery charge is depleted. In this case, dock the robotic

vacuum cleaner to the charger station after turning the

Power Switch on.

- Note that turning the Power Switch off will reset all

settings.

- If no key is pressed for approximately 5 minutes

after turning the power on, the power is automatically cut to prevent the battery

discharging.To turn the power on again, press and hold the power (Run/Stop) button

on the main body or on the remote control for a short while.

DJ68-00620Z(0.0).indb 20DJ68-00620Z(0.0).indb 20 2013.1.8 9:38:34 AM2013.1.8 9:38:34 AM

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 139 140

Brak uwag

Samsung SR8875 Instrukcja Użytkownika Strona 20