Samsung RSE8KPAS Dokumentacja Pobierz pdf (Strona 18)

● The Ice-maker is referred to the device with an automatic ice production, storage in the ice bucket and dispensing

through the ice chute.

1) Preparation of Ice-maker

1-1) Connect the water line to the water supply valve of refrigerator to supply water. (See how to connect a water

supply line in the owner’s manual.)

1-2) Push the bucket back fully so that the guide-ice of ice maker should not touch the back of bucket. (If the back of

bucket touches the guide-ice of ice maker, the ice maker will not make ice any more because of a ice full signal.)

1-3) It takes 6 hours to harvest a first ice, and throw away 2-3 times of these ice to make sure the supplied water clean.

2) Initial Operation function

2-1) Whenever the power is on, the control board checks the ice tray leveling with the leveling switch with in 2 seconds.

2-2) If the levelling switch is not in the off position, the geared motor will turn to the initial position to level the ice tray.

2-3) When the ice tray is leveled, it will remain this position for 2 hours (1 cycle time for ice production).

2-4)

After 2 hours, the sensor located under the ice tray will measure the tray temperature. If the temperature is maintained

lower than -17 for 5 minutes, and the ice full switch is off position, the ice tray twisting process will begin.

- Horizontal Leveling upon Initial Power On

Operating Instructions & Installation

Push the bucket back fully so that the

lever should not be pushed up.

3-9) Ice-Maker Function

Clockwise

Rotation(CW)

Counter

Clockwise

Rotation(CCW)

Ice Eject

S/W

880ms

(1) (2) (3)

850ms

2sec 1sec

200ms

1sec

Standby

1sec

Standby

Max Twist Point Horizontal Position Horizontal Position

(Finish)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 89 90

Brak uwag

Samsung RSE8KPAS Dokumentacja Strona 18