Samsung RSE8KPAS Dokumentacja Pobierz pdf (Strona 23)

Alignment and Adjustments

4-1)

Forced Operation Function (Pull-down / Refrigerator Defrost / Refrigerator . Freezer-Defrost / Cancellation)

● This function enables a pull-down mode, a defrost mode for the refrigerator only, a defrost mode for the freezer and the

refrigerator at the same time, and a cancellation of this function.

● Press fridge and Power Freeze. buttons for 8 seconds simultameously to get in the ready mode for a forced operation.

● The display panel will return to normal after 20 seconds in the ready mode.

●

At the ready mode, press any button(except Ice Type and Child Lock) once to start a pull-down operation, twice for a defrost cycle for

the refrigerator, three times for a defrost cycle for the freezer and the refrigerator, and finally four times for cancellation of this function.

● Another way to cancel this function is to simply plug out and in the power cord.

1) Pull-down Operation

1-1) At the ready mode, press any button once then the buzzer will beep (ON for 1/2 second and OFF for 1/2 second)

until this mode is cancelled.

1-2) At this pull-down mode, the compressor will start immediately (No 5 minute delay) and if the system is in the defrost

cycle, it will be cancelled right away.

note)

If this pull-down mode begins right after the compressor was off, the compressor may not start to run due to an overload condition.

1-3) At this mode, the compressor and freezer fan will operate continuously for 24 hours and the refrigerator fan will be on

and off according to the set temperature.

1-4) After pull down operation, the system will be cycled at -25 for the freezer and 1 for the refrigerator.

1-5) In order to cancel this mode at any time, select the next mode on the ready mode or power off the system.

notch)

After pull down operation, defrost will be followed for freeezer and refrigerator

2) Defrost operation

2-1) At the pull-down mode, press any button again on the ready mode to begin the defrost cycle for the refrigerator.

2-2)

The beep sound continues for 3 second at the beginning, then ON for 3/4 seconds and OFF for 1/4 second until this mode cease.

2-3) After this operation, the system will come back to normal operation.

2-4) At this mode, press any button again on the ready mode to operate the defrost cycles for both compartments.

2-5) The beep sound continues for 3 seconds at that time, then ON for 1/4 second and OFF for 3/4 seconds until the

defrost operation cease.

3) Cancellation

3-1) At the R,F-Defrost mode, press ant button again on the ready mode to return to a normal operation.

3-2) Simply unplug the power cord, then plug it again to return to a normal operation.

4-2) Self-Diagnostics Function

1) Self-Diagnostics in the initial Power ON

1-1) The control board performs a self diagnostics test within 1 second and check out the temperature sensors abilities.

1-2) If a sensor failure occurs, a corresponding LED segment will blink without a beep.

1-3) When a LED segment blinks, only the cancellation function (Press Power Freeze and Vacation buttons

simultaneously for 8 seconds) is acceptable.

1-4) After a replacement of bad sensor or a cancellation of this function, this self diagnostics will end.

2) Self-Diagnostics in the normal operation

2-1)

To select this function, press Power Freeze and Vacation buttons simultaneously for 8 seconds with an audible tone.

2-2)

In the self diagnostic mode, only corresponding LED segments will be illuminated (see the check list on the next page)

2-3) After a 30 second illumination of error signal, the system will return to the normal operation.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 89 90

Komentarze do niniejszej Instrukcji

Brak uwag

Samsung RSE8KPAS Dokumentacja Strona 23

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Samsung RSE8KPAS