Samsung SONOACE R3 Instrukcja Użytkownika Pobierz pdf (Strona 140)

100

101

User Manual

5-16

2D Trace

This is a basic measurement that is available in all diagnosis modes. You can measure the circumference

and area of an irregular object in a 2D image.

You can measure up to 4 distances. When taking more than one measurement, use measurement cursors

with dierent shapes to dierentiate them.

1. Press the Softmenu button [2] Area / Circ to select 2D Trace. “2D Trace” is displayed on the left side of

the screen.

2. Use the trackball and the Set button on the control panel to specify the start point for tracing over

the contour of the measurement area.

▶

Place the cursor at a desired position with the trackball, and press the Set button.

3. Trace the curve so that the measurement cursor returns to the start point, and then press the Set but-

ton.

NOTE: Trace lines must be closed. If you press the Set button before tracing is complete, tracing

may be done over a straight line between the current point and the start point, resulting in a

signiﬁcant error.

4. When the measurement is nished, its result is shown on the screen.

▶

Circ.: Circumference of Object

▶

Area: Area of Object

▶

Avg.(C): Average Circumference

▶

Avg.(A): Average Area

The equations used for Trace measurement are as follows:

, (N = 1,2… last point)

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 441 442

Komentarze do niniejszej Instrukcji

Brak uwag

Samsung SONOACE R3 Instrukcja Użytkownika Strona 140

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Samsung SONOACE R3