
Chapter 3 Starting Diagnosis
3-3
Power Supply
Boot the system for use.
CAUTION: Make sure to connect the probe and peripheral devices that will be used before
powering on the system. If you attempt to connect them during system use, it may lead to patient
injury or fatal damage to the console.
Powering On
Press the On/O button when the power is o. Booting begins, and the product logo appears on the screen.
When booting is completed, the 2D mode screen appears in End Exam status.
CAUTION: Before starting the diagnosis, you must register the patient information.
Powering O
Press the On/O button while using the system, then disconnect AC adapter mains plug from the power
outlet.
CAUTION: If you hold down the On/O button for five seconds or longer, the product power is
turned off forcibly. This may cause hard disk damage.
NOTE:
X
During system booting, do not press any key on the keyboard. It may cause product
malfunction.
X
The product should be turned on about five seconds after the power switch at the back of the
product is turned on.
X
Disconnect the AC adapter mains plug from the outlet to ensure the system is disconnected from
the power source.
Komentarze do niniejszej Instrukcji